BDV CXPS, User Manual

Page: 126 / 128

U P G R A D I N G F I R M W A R E
120
Reference Edition 1.07 CXPS Manual
3 Change the directory to the directory (folder) into which the firmware upgrade was
downloaded from the task “Download or Copy Firmware Upgrade to the Control
Computer.” In our example this is done by entering the command:
cd\upgrade
.
The new command prompt is
C:\upgrade>
.
4 Open the 10/100T Network Connection between the control computer and the FTP
Server within the CXPS by typing in the commands:
ftp <ip address>
User: bdv
Password: blackdiamond
A prompt sign appears: >
5 Type the command:
bin
A command prompt appears again: >
6 Type the command:
put <filename>
, where the file name is the name of the file you
downloaded in Step 2 of “Download or Copy Firmware Upgrade to the Control
Computer.”
In our example, the command is:
put bdvcxps.bin.xxx
7 Close the connection to the CXPS ftp server by typing the command:
quit
The connection to the CXPS ftp server is closed.
8 Open a Telnet session with the CXPS by typing the command:
telnet <ipaddr>
8998
The Telnet session is initiated.
9 Enter the network password.
The default password is “blackdiamond”.
10 Issue the upgrade firmware command in one of two ways:
a
From the serial port terminal, issue the RS-232 command:
ufw
Progress information about the upgrade process appears on the terminal.
b
From the Ethernet connection Command Prompt, type in the command:
ufw
11 The upgrade process takes approximately 2 - 3 minutes. When the upgrade is done,
you are instructed to power cycle the CXPS.
12 Type the command:
rfd
NOTE:
If the IP address is not known, establish RS-232 control of the CXPS and
issue the
SHOWNET
command. This returns the IP address of the device.