BCN3D ignis, Instruction Manual

Page: 30 / 55

30 Instruction Manual
Introduction to the general interface
Press the “speed” button when you are in the main
menu and this will appear: After choosing a file to preview on the main menu, the
user may press the “enter” menu to move the cursor to
the first layer, following this you can use the
keys to select the layer that you wish to modify or see
its values.
After pressing “z/u” you can move the green box to
select the parameter you wish to change. The new
value is inputted as in the previous sections and to
confirm the value press “OK”, otherwise press “Esc”.
Press the “max power” or “min power” button when
you are on the main menu and the following screen
will appear:
Press the “z/u” key and you can move the green block
up and down to select which of the values you wish to
modify. To modify the value, you use the same method
as with the speed.
Press the keys to move the cursor in the
numeric area and press the keys to select a
value. Finally, press the “enter” key to save any changes.
If you want to erase the change you must press “Esc”.
Speed selector: Options for layer parameters
Select the maximum and
minimum power: