BCD-RGD-804P-MT
15
D. Access management configuration
Enter [Switch] →[Access Management] navigation column,Page is used to regulate the access management. Select Open
access control management mode, click on the “Add New Entry” button, typing “Start IP Address (beginning IP address)”,
“End IP Address (End IP address)”, select “HTTP / HTTPS”, “SNMP”, at least select a permissible service.
Click [Save] button to complete the access management configuration. Check delete selection on the corresponding
clause, click the check box to complete the deletion.
Add New Entry:
Click to add a new interface.
Delete:
Interface items
Configuration
Introduction
Factory setting
Mode
Disable/Enable
off/one access control management
Disable
VLAN ID
1-4095
IP segment belongs VLAN
1
Start IP Address
IP Address
Access the start IP address
0.0.0.0
End IP Address
IP address
Access the end IP address
0.0.0.0
HTTP/HTTPS
Select / not selected Selected, The IP address can accessed through HTTP/
HTTPS
Not selected
SNMP
Select / not selected Selected, The IP address can accessed through SNMP Not selected
5.2.2.4 SNMP Configuration
A. SNMP system configuration
Enter 【SNMP configuration【→【System【navigation
column,If your network is configured with the SNMP server,
the switch can configure SNMP parameters, connect the
SNMP server. When selected SNMP v3 version needs to be
configured for specific functional parameters about SNMP
v3 security certification, groups, views and so on.
