43
AACBL4A-DOOR
CARD SWIPE SYSTEM INSTRUCTIONS
Option #1:
New card swipe systems may come with a standard 9 pin
Molex connector.
Simply plug this connector and plug into your card swipe
reader.
Option #2:
If your card swipe systems does not have a standard 9
pin Molex connector, then you will have to splice wires into
the AACE6517 harness. Use the Green and Black wires
for coin signal.
Coin Switches and Lights
In “Payout Settings” menu:
Set “Credits Per Play” to 1
Set “Card Swipe” to Enabled
How to Update Software
The software is programmed onto a SD Card
There is separate software for the game main board and the Marquee Sign main board.
AAMBRPI-SQ
Rasp Pi Main Board
Game main board SD Card location
AAMBRPI-SQ-M
Rasp Pi Marquee
Marquee Sign main
board SD card location
To remove: Push gently into board and let it pop back out - remove from board.
To install: Push gently into board until it clicks.
SD Card part number is AASD0008A - please specify game location when ordering.
UCL—Universal Card Link Connector for Card Swipe Systems
Orange is Inhibit wire
White is the Ticket Enable
Black is Ground
Blue is the Ticket Notch
Green is Coin Signal
Red is 12 Volts DC
AACBL4A-DOOR
Coin Switches and Lights
UCL—Universal Card Link Connector for Card Swipe Systems
Orange is Inhibit wire
White is the Ticket Enable
Black is Ground
Blue is the Ticket Notch
Green is Coin Signal
Red is 12 Volts DC
AACE6517
AACE6517
In “Payout Settings” menu:
Set “Credits Per Play” to 1
Set “Card Swipe” to Enabled
There are 3 mixing motors on the playfield. They each rotate to push the balls
back uphill.
To remove and replace:
1.) Remove enough of the #2 square bit screws to allow the front plexi to bend
upward and outward.
2.) Remove the 4 Phillips screws holding on the cover.
3.) Remove the 2 screws holding gear.
4.) Remove the back door and remove the 2 of #2 square bit screws and remove
motor housing from back of game.
5.) Remove cotter pin from old motor, move hub to the new motor and install new
cotter pin..
6.) Re-install new motor into the back of the playfield and re-assemble.
How to Replace Mixing Motors
How to Replace Drop Button
The Drop Button is accessed from the top of the control panel.
To remove and replace:
1.) Remove all of the small black Phillips screws.
2.) Remove the 4 Phillips screws.
3.) Drop button can now be removes and replaced.
4.) Re-installation is the reverse of removal.
How to Remove Ball Tube
To remove the Ball Tube, the front protective cover must first be removed.
To remove and replace:
1.) Remove the 4 Phillips screws on the left side of the blue metal.
2.) Remove all of the small Phillips screws on the right side of the clear plexi.
3.) Remove the cover and set aside for later installation.
4.) Remove the 2 of #2 square bit screws.
5.) Lower the black plastic, lift tube up and out of cabinet.
6.) Clean or replace if needed. Part # A5PI6500
7.) Re-installation is the reverse of removal.
HOW TO
HOW TO
UPDATE SOFTWARE
REPLACE MIXING MOTORS
Summary of Contents for SQUIGGLE
Page 1: ...1 ...
