42
ADJUST COLOR SENSOR
HOW TO
How to Adjust Color Sensor
The color sensor is located in the top of the ball tube next to the monitor.
If the game is not registering the yellow ball in the correct spot, this color sensor may be dirty,
too far away from the balls, or too close to the balls.
To adjust:
1.) Remove the 4 Phillips screws on the left side of the blue metal.
2.) Remove all of the small Phillips screws on the right side of the clear plexi.
3.) Remove the cover and set aside for later installation.
4.) Loosen the 2 of 3/8 inch nuts.
There are 2 beams on the sensor board.
Top sensor
Bottom sensor
Both sensors watch the balls as they pass by.
5.) Move the sensor board closer or further away from the tube
according to suggestions below:
Enter menu, select “Diagnostics”
Select “Start Blowers” to allow red balls to fill tube.
Select “Release Yellow Ball” to allow yellow ball to fall into tube
The screen will show 2 columns of balls. The left column is the top sensor
and the right column is the bottom sensor on the circuit board.
As the balls fill the tube, the display will show where they land:
When aligned correctly, there will be only 1 yellow ball in each column.
If there are more than 1 yellow ball in each column, then the sensor board is too
close to the tube and should be moved a bit further away.
It is normal that there is one ball missing in the top left column.
If there are more than the one ball missing, then the sensor board is too far away
from the tube and should be moved a bit closer.
Select “Sort Balls” and start test over if needed.
6.) Re-install cover when finished.
If both sensors are unplugged - both yellow and red balls will come out of the red ball nozzle. The tube will be
filled for a long time. The game will try to release the solenoid a few times and the player will receive a play
again, then receive the minimum tickets for their ticket pattern.
Check Top Ball Tube Sensors means that one of the 2 sensors are not communicating.
It could be a faulty cable or dirty sensor. Clean with canned air, wipe sensor if needed.
Power cycle game to ensure good connection.
This column will
always be missing
one ball. It is normal
.
Summary of Contents for SQUIGGLE
Page 1: ...1 ...
