31
TROUBLESHOOTING
Troubleshooting Guide
Problem
Probable Cause
Remedy
No power to the
game
Unplugged.
Power strip turned off,
or plugs unplugged.
Circuit breaker tripped.
Line filter faulty.
Bad or overloaded power
supply.
Check wall outlet cable
(A5CORD5)
to line filter
(A5FI9010)
in back of game. Check AACE6529 cable to power strip.
Check rocker switch on power strip. Ensure
power cords are pushed up into power strip securely.
Reset power strip breaker switch or building
circuit breaker. Attempt to determine cause.
Replace line filter. (A5FI9010)
Refer to Power Supply Diagnostics
Bill Acceptor on,
no signal on
monitor, but
everything else
off
(Power Supply
not ON)
Power supply unplugged.
Rocker Switch on power
supply is Off.
Power supply shutting
down because of 12 V
overload.
Faulty power supply.
Insure power supply is plugged into power strip.
Make sure rocker switch is set ON.
See power supply diagnostics to isolate bad component.
A bad solenoid or 12 volt short would cause this.
Refer to Power Supply Diagnostics section.
Marquee LED
lights are not
working
LED strip faulty
Faulty Cable
Remove marquee and examine LED strip. (AACE6542)
Check cables from LED strip to power distribution board.
(AACE6542, AACE6533, AACE6500)
Drop Button
LED’s not
working
(
Power goes
through RGB
Control Light Board)
LED strip faulty
Faulty Cable
Faulty RGB Control Light
Board
Open front door and examine circuit board with LED’s.
Replace if needed. (AACE6541)
Check cables from LED board to RGB Control Board
(AACE6541, AACE6504)
Swap cables to a different socket on the board. Replace
RGB Board if needed. (Part # AACB6502)
Drop Yellow Ball
center ball drop
not
Working
(
Power goes
through RGB
Control Light Board)
LED strip faulty
Faulty Cable
Faulty RGB Control Light
Board
Examine LED strip. There should be 12 Volts present.
Replace LED strip if needed. (AACE6555)
Check cables from LED strip to RGB Control Board
(AACE6556)
Swap cables to the different socket on the board. Replace
RGB Board if needed. (Part # AACB6502)
Ball Light
color LED
Board not
working
(
Power goes
through Edge
LEDS’s first,
coming from I/O
Aux Board)
Faulty Earlier Component
Extra 12 Volts to LED
LED strip faulty
Faulty Cable
Faulty I/O Aux Board
Signal first goes through the outside edge colored lights.
Ensure these outside edge lights are functioning properly
Make sure 12 volts is being back-fed through AACE6507
Examine LED board. Replace LED board if needed.
(AACE6552)
Check cables from LED board to I/O Aux Board
(AACE6511, AACE6519, AACE6510)
Swap cables to a different socket on the I/O Aux board.
Observe if the problem changes to the center track LED’s
Replace I/O Aux Board. (Part # AACB9601-SQ)
Summary of Contents for SQUIGGLE
Page 1: ...1 ...
