44
REPLACE DROP BUTTON
The Drop Button is accessed from the top of the control panel.
To remove and replace:
1.) Remove all of the small black Phillips screws.
2.) Remove the 4 Phillips screws.
3.) Drop button can now be removes and replaced.
4.) Re-installation is the reverse of removal.
REMOVE BALL TUBE
To remove the Ball Tube, the front protective cover must first be removed.
To remove and replace:
1.) Remove the 4 Phillips screws on the left side of the blue metal.
2.) Remove all of the small Phillips screws on the right side of the clear plexi.
3.) Remove the cover and set aside for later installation.
4.) Remove the 2 of #2 square bit screws.
5.) Lower the black plastic, lift tube up and out of cabinet.
6.) Clean or replace if needed. Part # A5PI6500
7.) Re-installation is the reverse of removal.
HOW TO
HOW TO
CLEAN COLOR SENSOR
Use a can of air to spray in the small holes in the top of the tube.
This should remove any debris that has accumulated on the sensor.
REMOVE BALL TUBE
To remove the Ball Tube, the front protective cover must first be removed.
To remove and replace:
1.) Remove the 4 Phillips screws on the left side of the blue metal.
2.) Remove all of the small Phillips screws on the right side of the clear plexi.
3.) Remove the cover and set aside for later installation.
4.) Remove the 2 of #2 square bit screws.
5.) Lower the black plastic, lift tube up and out of cabinet.
6.) Clean or replace if needed. Part # A5PI6500
7.) Re-installation is the reverse of removal.
HOW TO
HOW TO
The Drop Button is accessed from the top of the control panel.
To remove and replace:
1.) Remove all of the small black Phillips screws.
2.) Remove the 4 Phillips screws.
3.) Drop button can now be removes and replaced.
4.) Re-installation is the reverse of removal.
REPALCE DROP BUTTON
HOW TO
REPLACE DROP BUTTON
The Drop Button is accessed from the top of the control panel.
To remove and replace:
1.) Remove all of the small black Phillips screws.
2.) Remove the 4 Phillips screws.
3.) Drop button can now be removes and replaced.
4.) Re-installation is the reverse of removal.
REMOVE BALL TUBE
To remove the Ball Tube, the front protective cover must first be removed.
To remove and replace:
1.) Remove the 4 Phillips screws on the left side of the blue metal.
2.) Remove all of the small Phillips screws on the right side of the clear plexi.
3.) Remove the cover and set aside for later installation.
4.) Remove the 2 of #2 square bit screws.
5.) Lower the black plastic, lift tube up and out of cabinet.
6.) Clean or replace if needed. Part # A5PI6500
7.) Re-installation is the reverse of removal.
HOW TO
HOW TO
HOW TO
HOW TO
HOW TO
REPLACE DROP BUTTON
CLEAN COLOR SENSOR
REMOVE BALL TUBE
Summary of Contents for SQUIGGLE
Page 1: ...1 ...
