50
3.
Refer to the upper right hand corner of the screen for
Handshaking line status. RTS, CTS, DSR, and DTR
should all be HIGH. The DCD line is not looked at by
the terminal emulation program therefore its status can
be ignored. If these signals are not high at this point,
check to ensure the correct cable is connected.
4.
Depress function key: F1.
NOTE: The F1 key in TERM sends the character
sequence
Control-T
(14 Hex) followed by the capital C
character (43 Hex).
The main configuration menu will appear as shown in
Section 7.2.1
.
From this point on, configuration of Print Master will be accomplished
by following the menus that will prompt you.
Print Master will respond to the receiving of
Control-T
and capital
C
with an identification block and a menu of the configuration options
available, similar to the following for the Model 706C:
Bay Technical Associates
Model 706C Print Master
Copyright 1989
Revision 3.00
Total Memory : 1024K Bytes
Status..............................1
Set Serial Port Configuration.......2
Set Input Inactivity Timeout........3
Set Number of Printers..............4
Program Printer Select Code.........5
Set Printer Select Mode.............6
Set Form Feed Mode..................7
Program Header Page Message.........8
Exit................................X
Enter Request:
NOTE: Menu selection is case sensitive. It is recommended that
your keyboard be in the CAPS LOCK position.
