F/W Version 2.1
13
12.6.
Servo Limits
This function is used to set the mechanical limits for aileron, elevator and rudder servos. The max limit is
determined by the maximum possible control travel of the mechanism. The limits can be set between 0-100%
corresponding to the pwm pulse length from 1020 to 2020μs. The default setting is 100%. When adjusting, switch
the controller to the 3D flight mode first, move the sticks to one
side, the servo will move to the set limit, increase or decrease the
value until no binding occurs by using the program card or
config tool. Always try to achieve the maximum possible travel
limit to obtain the best performance.
12.7.
Gyro On-off
It is used to turn on or off the gyro for each channel. When set to OFF, all gyro functions
for the corresponding channel will be disabled whatever the flight mode is.
12.8.
Gyro Direction
It is extremely important to make sure that the gyros of all channels are
compensating in the correct direction before flight, otherwise it could lead to losing
control or even crash during flight
! To perform the examination, power on the aircraft,
pick it up and check it by following the illustrations below. Turn it to REV(Reversed) if
the gyro compensates in a incorrect direction.
The gyro directions of Aileron 2 and Elevator 2 can be set independently since Ver.2.1!
AILERON
Quickly move the right wing downward around the roll axis. The right aileron should flap down
and the left aileron flap up as shown.
ELEVATOR
Quickly move the nose of the aircraft downward around the pitch axis. The elevator should
flap up as shown.
HTTP://WWW.BAY-TEC.DE
Sept. 12, 2013