F/W Version 2.1
6
CH1
CH2
CH3
CH4
CH5
CH6
CH7
Aileron
Elevator
Throttle
Rudder
Flight Mode
Aileron 2
Master Gain
A 3-position switch (SE) is assigned to channel-5 for flight mode switching, which is implemented by using the
GEAR function in the radio system. A knob (RD) is assigned to channel-7 for the adjustment of master gain,
surely you might use a 3-position switch instead to get a 3-level gain control if you like.
6.4.
Wiring
Connect all the required channels between the controller and the receiver, using the included plain 3-wire cables,
which have only one lead of the control signal on the receiver side, and are connected to the controller on the
combined connector. The controller requires at least 3 receiver channels, up to 7 channels. The channels of AIL,
ELE and RUD must be connected all the time otherwise the controller will not work. The other 3 pins should be
connected according to the AUX mode currently selected. The throttle servo or ESC is connected as normal to the
throttle channel of the receiver without bridging the controller. The illustration below shows the wiring method
only for AUX Mode-3, which is used in this case.
HTTP://WWW.BAY-TEC.DE
Sept. 12, 2013
