Instructions pH FUN V1
Page 9 of 28
2
Putting into operation
Before putting the system into operation, all previously described steps must be performed and the conditions specified
there must be met!
Then proceed as follows:
•
Insert the suction lance into the full canister with pH-Minus (pH-Plus) and tighten the screw connection firmly.
Ensure that the tip of the suction lance with the switch is located at the very bottom of the canister.
•
Connect the BNC connectors of the suction lance with the socket on the lower side controller (see also Chapter
1.5.1 Connections on the controller housing
•
Connect the pH FUN to the mains (connection via the power supply of the circulating pump).
The menu for the initial operation is then displayed.
Initial operation menu of the pH FUN
The initial operation menu appears automatically after a new pH FUN device is switched on for the very first time.
This menu guides you through the most important settings:
•
Language
Select the desired language using the arrow keys
and confirm with
.
•
Default
Select the default value set (standard settings) corresponding to your location using the arrow keys
.
There are 5 sets available. Use "Europe" for all countries not listed. Confirm with
.
•
Pool volume
Enter the volume of the swimming pool in m³ (cubic meter) using the arrow keys
and confirm with
.
The input of the pool volume serves as basis to the pH FUN for the determination of the optimal dose amount.
•
pH7-Calib.
Perform the pH7-Calib. (calibration of the pH measurement) to guarantee a correct and precise measurement
of the pH value in the pool water. Please proceed as described in Chapter 6 Performing the pH7 calib.
•
To ensure that the pH FUN is able to quickly and safely perform its measuring and controlling function from the very
beginning, it is recommended that you bring the pH value of the pool water to the optimal value (pH setpoint) of 7.2
manually.
To do this, you can trigger a manual dosing (see Chapter 5 Performing a manual dosing). You can read the current
pH value on the display of the pH FUN.
Alternatively, for larger deviations of the pH value, you can also utilise pH-Minus/pH-Plus from BAYROL in granular
form. Here you must absolutely observe the dosing instructions on the product packaging. A check of the pH value
is possible using a commercially available pool tester. You can also perform this step before putting the pH FUN
into operation.
•
Once the pH value is in the optimal range, you can proceed with your preferred method for water disinfection.