Installing the HRPSU
114312 Rev. C
2-11
4.
Refer to Figure 2-8 and attach each flange to the HRPSU as follows.
•
When the HRPSU is to be mounted to single posts (center-of-gravity
mount), attach the brackets with the flange facing the rear of the HRPSU,
as shown on the left.
•
When the HRPSU is to be mounted to double posts (flush mounted, as in
Figure 2-8), reverse the brackets, as shown on the right in Figure 2-8. The
front of the HRPSU will be flush with the rack-mounted network devices.
Figure 2-8.
Attaching Flanges to the ASN
5.
Place the HRPSU on the angle brackets in the rack. Align the flange holes
with the holes in the front vertical supports on the rack (Figure 2-9).
If the rack holes are
not threaded
, place cagenuts over them.
Screws
(8 places)
HRP0006A
