Supplied By www.heating spares.co Tel. 0161 620 6677
3
INTRODUCTION - Page 3
NOTICE
DISCOLOURATION OF WALL SURFACES
Most heating appliances generate warm air convection
currents and transfer heat to any wall surface against
which they are situated.
Some soft furnishings (such as blown vinyl wallpapers)
may not be suitable for use where they are subject to
temperatures above normal room levels and the
manufacturer’s advice should be sought before using
this type of wall covering adjacent to any heating
appliance.
The likelihood of wall staining from convected air
currents will be increased in environments where high
levels of cigarette smoke or other contaminants exist.
WARNING
The addition of anything that may interfere with the
normal operation of the appliance (e.g. FLUE DAMPERS,
ECONOMISERS etc.) without the express written
permission of BAXI LIMITED could invalidate the
appliance warranty and infringe the GAS SAFETY
(Installation and Use) REGULATIONS.
Description
The Baxi Baroque Super and Baxi Arena Super are living
flame effect gas fires with a heat input of 5.57 kW (19,000
Btu/h) and an output of 3.40 kW (11,590 Btu/h) at its
maximum setting. The fires are available for use with Gas
Type G20 (Natural Gas) at 20mbar supply pressure. The
fires are suitable for either hearth or wall mounting and are
designed to be used on NATURAL GAS ONLY.
NOTE: The
data and spillage test labels are located on the inner fire
support feet behind the fender front.
Electronic ignition is provided to light the pilot. The fire is
controlled by a control knob positioned on the right hand side
of the case. This control knob has six positions giving a
choice of four output settings.
Position
-
OFF
Position
-
PILOT
Position 1
-
LOW
Position 2
-
MEDIUM
Position 3
-
MEDIUM/HIGH
Position 4
-
HIGH
The artificial coal bed may be illuminated by concealed bulbs
as and when required. The light effect is operated by a
switch situated below the control knob. It may be used
whether the fire is ON or OFF.
The fire is manufactured to British Standards 5258 Part 5
and 6332 Part 2.
Installation
The installation must be carried out by a CORGI Registered
Installer or other competent person and be in accordance
with the relevant requirements of the GAS SAFETY
(Installation and Use) REGULATIONS, the BUILDING
REGULATIONS (Scotland) (Consolidation), the LOCAL
BUILDING REGULATIONS and the CURRENT I.E.E.
WIRING REGULATIONS. It should also be in accordance
with the relevant BRITISH STANDARD CODES OF
PRACTICE.
Important Information
This product contains Refractory Ceramic Fibres (R.C.F.)
which are man-made vitreous silicate fibres. Excessive
exposure to these materials may cause temporary irritation
to eyes, skin and respiratory tract. Care must be taken when
handling these articles to ensure the release of dust or fibres
is kept to a minimum.
To ensure that the release of fibres from these articles is
kept to a minimum, during installation and servicing it is
recommended that a H.E.P.A. filtered vacuum is used to
remove any dust, soot or other debris accumulated in and
around the appliance. This should be performed before and
after working on the installation.
It is recommended that any replaced item(s) are not broken
up but sealed within heavy duty polythene bags and clearly
labelled “R.C.F. waste”. This is not classified as “hazardous
waste” and may be disposed of at a tipping site licensed for
the disposal of industrial waste.
Protective clothing is not required when handling these
articles but it is recommended that gloves are worn and the
normal hygiene rules of not smoking, eating or drinking in
the work area are followed and always wash hands before
eating or drinking.
