CLEANING AND MAINTAINING THE HEATER
How do I clean my heater?
The heater fascia and glass parts need only to be wiped clean with a dry soft cloth, do
not use polishes or abrasive materials. The Adage, Alisa, Anthem and Ocean heaters
may have finger prints on the fascia surface. These can be removed by applying a small
amount of ‘baby oil’ to a lint free non-abrasive cloth and wiping the surface. Use a
clean cloth to remove the oil.
I have a problem with my heater!
Important Safety
Before undertaking maintenance or replacing the light bulb always disconnect the
heater from the electricity supply by removing the 3 pin plug and allowing the
heater to cool completely.
1. My heater is on but there is no light.
This is possibly a light bulb failure. Remove the light bulb as detailed below and check
it in a table lamp that is known to work. If it does not work in the table lamp then
replace it as below.
The light bulb fitted to this heater is a long life compact fluorescent type, but due to the
indeterminate life span and ease of replacement, it is specifically excluded from the
guarantee.
To replace the light bulb.
1.
To gain access to the light bulb, remove the loose coals / pebbles from the fuel
support and place them onto an old newspaper or plastic bag. This will prevent them
from marking the surface.
2.
Remove the firefront, (On the Adage and Ocean heaters it will be necessary to
remove the whole fascia), see figure 2 & 3 and the section headed “ Removing the
fascia”.
3.
Note the position of the dark area on the light bulb shroud. Remove the light bulb
shroud by sliding it to the left.
4.
Replace the light bulb with an 18 - 20 Watt (maximum) Edison screw, compact
fluorescent light bulb eg. ‘Philips Ecotone’. Do not use standard tungsten light bulbs
due to the excessive heat.
5.
Refit the light bulb shroud into the position noted earlier. Refit the firefront / fascia
and refit the coals.
2. My heater is on but there is no light or heat.
The first thing to do is check the wall socket. To do this plug in a known working
appliance. If the appliance you have plugged in works then there is a good chance that
Page 16
INSTALLER AND OWNER GUIDE
