17.7 To remove the appliance from the fireplace.
1.
Remove the burner unit (See section 17.2).
2.
Slacken the hexagonal adjusters on the cable retainers and unscrew the thumbscrews
to release the cables (See section 9.1).
3.
Refit as described in the relevant installation sections. Make sure gas soundness,
sealing, spillage test and performance are satisfactory.
17.8 To remove the fascia.
Important :Before removing the fascia check to see if the foam seal covers the
flange on the rear of the fascia. If it does then ensure that a replacement foam seal
is available.
1.
Remove the appliance from the fireplace (See section 17.7)
2.
If the foam seal covers the flange on the rear of the fascia remove the foam seal from
the rear of the convector box.
3.
For models fitted with a three section fascia.
Carefully lift off the top fascia piece and place carefully aside. Carefully remove the
two side pieces and place carefully aside.
3.
For models fitted with a one piece fascia.
Carefully hold and lift the fascia clear of the convector box and place carefully aside.
4.
Refit in the reverse order (See section 8.2 - ‘Fitting the fascia’)
5.
If the foam seal was removed previously fit the replacement foam seal (See as in
section 8.4).
6.
Refit the convector box as described in the relevant installation sections. Make sure
gas soundness, sealing, spillage test and performance are satisfactory.
Page 32
INSTALLER GUIDE
