3.
Place a type “A” coal between
the front and rear base coals with
the letter “A” upright and so that
the coal is against the left side of
the firebox (See figure 21).
4.
Place a type “B” coal between
the front and rear base coals as
shown in figure 22. The letter “B”
should be upright.
5.
Place a type “A” coal between the
front and rear base coals with the
letter “A” upright. The top of the coal
should rest against the centre coal of
the rear base coal as shown in
figure 23.
6.
Place the remaining type “B”
coal at the right side of the firebox
between the front and rear base
coals. The letter “B” should be
upright. The coal should touch the
right side of the firebox (See
figure 24).
7.
Place the remaining type “A” coal
between the front and rear base coals.
The letter “A” should be upside down
with its rear face between the right
and centre coals of the rear base coal.
Angle the coal so that the gap
between it and the type “B” coal to
its right is appreciably larger than
the gap between it and the type
“A” coal to its left but do not have
it touching the type “A” coal. This
will give the best flame effect (See
figure 25).
Page 22
INSTALLER GUIDE
Figure 25.
Figure 24.
Figure 23.
Figure 22.
Figure 21.
