10. FITTING THE CERAMICS
The installer and owner guide for the ceramic fuel effect is supplied with the ceramic
fuel effect. It is important that the installer and owner guide for the ceramic fuel effect
be placed inside or attached to this guide and handed to the customer following
completion of the ‘final review’ section.
11. FITTING THE FASCIA AND FIREFRONT
11.1 Fitting the Dream fascia.
1.
Place the fascia against the fireplace front surface so that the two retaining plates at
the back of the fascia are above the two upper
retaining brackets at the top of the convection
box.
2.
Lower the fascia making sure that the rear
retaining plates locate fully into the retaining
brackets on the convection box (See figure 35).
If the inlet pipe runs along the front of the
fireplace, the bottom of the fascia will have to
be swung forwards to clear the pipe while
lowering the casting.
3.
Align the bottom fixing holes with those in
the convection box. Fix the bottom of the
fascia to the convection box with two screws
(See figure 36).
4.
Supplied with the fire is a self adhesive
control position label. Peel the backing from
the label and place as in figure 35.
Page 31
INSTALLER GUIDE
Figure 36. “Dream” fascia
bottom fixing.
Figure 35. “Dream” fascia top location
