7 of 10
Any reproduction, distribution, modification, or dissemination of these instructions without written permission from Bavarian Soundwerks is
expressly forbidden and a violation of international copyright law. Any violation will result in prosecution to the full extent available under
the law!
© 2006 Bavarian Soundwerks, LLC.
2195 Defoor Hills Rd., Suite D, Atlanta, GA 30318
P: 404.963.8857 |
www.bavsound.com
8. Plug your new midbass drivers in like you did with the front midbass drivers. Use the chart below
to match wire colors.
Driver Side
Yellow (+)
Red
Negative (-)
Connects to
Black
Passenger Side
Blue (+)
Red
Brown (-)
Connects to
Black
9. Install the new midbass drivers in the factory locations using the supplied long fine thread
screw/washer combination.
Rear Tweeter Installation
1. Before beginning this step, plug in your hot glue gun so that it will be ready by the time you need it.
2. Unscrew the ring that secures the tweeter to the back of the panel. (Figure 19) Remove the entire
tweeter assembly from the panel.
3. Pry the factory tweeter by lifting from the edges of the tweeter using a small screwdriver or pick
tool.