4 of 10
Any reproduction, distribution, modification, or dissemination of these instructions without written permission from Bavarian Soundwerks is
expressly forbidden and a violation of international copyright law. Any violation will result in prosecution to the full extent available under
the law!
© 2006 Bavarian Soundwerks, LLC.
2195 Defoor Hills Rd., Suite D, Atlanta, GA 30318
P: 404.963.8857 |
www.bavsound.com
Front Midbass Installation:
First, notice that the larger speaker in the lower panel is attached using three Phillips head screws. (See
below) These can also be Torx T20 or T27 bolts. Remove these, and place them with the other Torx bolts
which you have already put aside in a safe place, haven’t you?
☺
Reattach the new midbass driver to the door panel using the original factory hardware. If your factory
speaker had a foam baffle around it, remove it and reuse it on the new BSW midbass driver.
Tweeter/Midrange Assembly Removal/Installation:
You’ll first want to remove the entire tweeter/midrange assembly by removing the three Torx T20 screws that
attach it to the door panel. Once removed, again place the screws somewhere safe so as not to lose them.
You’ll simply reattach the new midrange/tweeter housing into place using the factory hardware that was
removed from the factory speaker housing.
Let’s take the door panel back over to the vehicle and make our final wiring connections with the midbass
drivers.
