Baumatic Ltd declines any responsibility for work carried out on
the appliance which is not in line with the instructions reported
in this manual.
Signals and warnings
Pump oil substitution warning
o
The vacuum-packer is equipped with a high-performance
vacuum pump, which is lubricated by special oil, designed for
this appliance.
o
During the use of the vacuum-packer, the oil undergoes normal
deterioration due to the absorption of impurities and liquids.
o
In order not to compromise the performance of the appliance, it
is necessary to undertake an oil change every 2500 cycles, which
equals around 150 hours of usage.
o
The appliance will signal when an oil change is required as all the
LED’s will flash and a long beep will sound.
WARNING: The oil change must only be carried out by an
authorised service engineer.
Insufficient vacuum signal
o
The vacuum-packer is installed with a mechanism which reveals
the level of vacuum reached inside the chamber and monitors
whether the appliance is working as it should be.
o
If the minimum level of vacuum (350 millibar pressure inside the
chamber) is not reached after around one minute, the cycle is
automatically disrupted.
o
The appliance signals the fault through the stop button flashing
for approximately twenty seconds along with an acoustic signal.
o
The signal stops when a new cycle is activated. If the cause is
not remedied, the signal will repeat.
o
If the insufficient vacuum signal should occur, check that the lid
is properly closed and the seal is properly inserted.
24