The cycle proceeds automatically in the following order:
o
The
evacuation
phase is signalled by the LED of the
preservation cycle button blinking for around two minutes.
o
The
soldering
phase is signalled by the LED of the preservation
cycle button coming on. This phase lasts approximately nine
seconds. A cooling phase will then follow which lasts around five
seconds.
o
During the next
discharge
phase, all the LED displays revert to
the initial start-up mode. The discharge valve is open for
approximately twenty seconds. During this time, the appliance
does not respond to any commands.
o
When the vacuum chamber is decompressed, it is possible to
open the lid and extract the sealed bag at the end of the
discharge phase.
o
The product will appear closely wrapped and compressed by the
bag. At the end of the cycle, an acoustic short beep is sounded
which indicates that the appliance is now ready for a new cycle.
By pressing the preservation cycle button during the air
evacuation phase, the vacuum-packer will pass to the soldering
phase.
The cycle can be interrupted early by pressing the stop button.
In this case, the vacuum-packer will not carry out the soldering
phase and the chamber will be decompressed.
Please wait for approximately twenty seconds and for the
acoustic signal before starting a new cycle.
14