Battipav elite 80 9000, Operating Instructions Manual

Page: 18 / 23

29
Battipav srl GB
CUTTING ON THE TABLE
CAUTION
BEfORE PERfORMING THE CUTTING OPERATIONS,
MAKE SURE THAT THE MATERIAL IS PROPERLY
LEANED AGAINST THE TILE STOPPER.
CAUTION
13 BEfORE STARTING THE CUTTING
OPERATIONS, THE OPERATOR MUST MAKE
SURE THAT AT LEAST 150 cm ARE LEfT fREE
AROUND THE MACHINE (Pos. 2 Picture 13).
IN ORDER TO WORK IN SAfETY CONDITIONS,
DO NOT LET OTHER PEOPLE REMAIN NEAR
THE MACHINE DURING THE CUTTING
OPERATIONS.
THE OPERATOR STANDS IN THE WORKING
POSITION (Pos. 1 Picture 13) DURING THE
DIffERENT MACHINE OPERATION PHASES.
14 By means of the locking lever, secure the motor
head
• Arrange the piece to be cut on the working
table at the desired measurement.
15 • Start the machine and wait until cutting
blade cooling water comes out, adjusting the
necessary amount by means of the water on-
off valve located on the blade guard
15 • Start the machine and wait until cutting
blade cooling water comes out, adjusting the
necessary amount by means of the water on-
off valve located on the blade guard.
16 In order to carry out any diagonal cutting, lean
the piece against the square as indicated in the
picture and go on with the cutting operation.
CUTTING ON THE TABLE IN 2 PASSAGES
MAX. H 130 mm
By adjusting the position of the cutting head using
the locking lever, it is possible to cut materials of a
height of up to 130 mm in 2 passages.
17 Put the motor head in position as indicated in the
picture in order to take advantage of maximum
cutting capacity.
• By means of the cutting square, arrange the
piece to be cut on the working table at the
desired measurement.
18
• Start the machine and carry out the first cut.
19 • Turn over the piece 180°, and repeat the cut.
CUTTING A SURfACE AT 45°
CAUTION
Before positioning the motor head, make sure that:
• the cutting tool is not moving;
• the sliding carriage is locked.
For cutting materials at 45°, move the motor head to
the jolly position:
• Using the 30 mm wrench provided, loosen the
motor head support screw
20
• Tilt the cutting head and tighten the support
screw again.
21 • By means of the locking lever, secure the
motor head.
22 • Position the piece to be cut on the sliding
working table and perform the cutting
operation.
CAUTION
THE JOLLY CUT ON CERAMIC OR ENAMELLED
MATERIAL MUST BE MADE WITH THE TILE UPSIDE
DOWN.