Basler L800k, User Manual, Page: 153 / 168

Troubleshooting
BASLER L800
k
6-1
Draft
6 Troubleshooting
6.1 Fault Finding Using the Camera LED
During bootup, the camera loads firmware and performs initial self checks. Once bootup is
complete, the camera performs a continuous series of self checks. If an error condition is
detected, the LED will begin flashing. The number of flashes indicates the detected error as shown
in Table 6-1.
If several error states are present, the LED outputs the error code that has the highest priority.
To get more information about the camera’s current condition, you can check the camera status
as described in Section
3.12 .
LED Description Priority
LED is solid green
for several seconds,
flashes orange and
then becomes solid
orange This is the normal LED sequence at power on or after a camera
reset. -
Solid orange The camera has power and is OK. -
LED flashes with
gradually increas-
ing frequency Indicates that the camera is busy performing a normal operation
such as generating shading tables. When the operation is complete,
the flashing stops. -
Continuous red
flashing An overvoltage condition has been detected. The flashing will stop
after the voltage has returned to normal and the camera is reset or
powered off and back on. 1
(highest)
Continuous fast
orange flashing General error.
Please contact Basler support. 2
Continuous slow
orange flashing One of the following errors is present:
• No FPGA firmware is available.
• Firmware available but error when booting the FPGA.
Please contact Basler support.
3
Table 6-1: Camera Status Indicators