Basler A640F, User Manual

Page: 114 / 188

Configuring the Camera
4-50
BASLER A640
f
DRAFT
4.4.2.7 Control and Status Registers for the Strobe Signal Function
The base address for the Strobe Signal control and status registers is:
Bus ID, Node ID, FFFF F2F0 0300
In each Strobe Signal register description, an “Offset from the Base Address” is provided. This a
byte offset from the above base address. The address of a strobe signal register equals the above
base address plus the indicated offset.
Values are stated in decimal format except when marked 0x. Values marked as 0x (e.g., 0x123)
are in hexadecimal format.
Bit 0 in each register is the most significant bit.
* If a bit is set to 0, the camera does not support this feature
If a bit is set to 1, the camera supports this feature
Register Name: Strobe Control Inquiry
Offset from Base Address: 0x000
Field Bit Description A641f
Value A641fc
Value
Strobe 0 Inq 0 Presence of the Strobe 0 signal feature 1 1
Strobe 1 Inq 1 Presence of the Strobe 1 signal feature 1 1
Strobe 2 Inq 2 Presence of the Strobe 2 signal feature 1 1
Strobe 3 Inq 3 Presence of the Strobe 3 signal feature 1 1
---. 4 ... 31 Reserved --- ---
Register Name: Strobe 0 Inquiry
Offset from Base Address: 0x100
Field Bit Description A641f
Value * A641fc
Value
Presence Inq 0 Strobe 0 signal feature is present 1 1
--- 1 ... 3 Reserved --- ---
Read Out Inq 4 The Strobe 0 value can be read 1 1
On/Off Inq 5 Strobe 0 control can be switched on/off 1 1
Polarity Inq 6 Strobe 0 polarity can be changed 1 1
---. 7 Reserved --- ---
Min Value 8 ... 19 Minimum value for Strobe 0 controls 0 0
Max Value 20 ... 31 Maximum value for Strobe 0 controls 4095 4095