Operating Instruction
54 / 74
117623-117723
EN
4. To end with, press 'Save' key (25,
Fig. 32).
5. Press the
'+'
key (24, Fig. 31) to
continue and add further dish names.
Removing Dishes From the List
To remove a dish from the list press and
hold its name for a few seconds. This
operation is only possible if the thermal
processing of this dish is NOT active.
Direct or Programmed Use
Rack Control can be used in direct mode
and in programmed mode.
Direct
use mode has been described in
the previous section 'Adding Dishes to
Thermal Processing Program Levels'.
Dishes are added after pressing START
key (and at the end of pre-heating, if
present).
Fig. 32
In the programmed use mode the dishes are added when the appliance is off
(STOP key is pressed), i.e. when no thermal processing takes place.
In such a condition the selected levels are not activated. They may be activated
only after pressing START key (and waiting until the end of pre-heating, if present),
one by one, by clicking on the time indicator field to the right.
Modifying Thermal Processing Time / Thermal Core Probe Setting
It is possible to change the thermal processing time or thermal core probe setting by
prolonged pressing of their keys.
1. In order to introduce modifications, call up the list of dishes first.
2. Then, use a longer press to select the name of a dish to be changed.
3. Enter the new thermal processing time (or thermal core probe temperature).
The dish name may also be modified this way.
4. To change the thermal processing time for a given dish during its thermal
processing, press the remaining time field and enter the new time or thermal
core probe temperature.