- 67 -
6.4.4 Time setting
Fig. 17
Set time of each phase (program part) by
pressing
S3
on the display. Set time with
use of knob
M
, increasing it in the
clockwise direction or decreasing in the
counterclockwise direction.
The settings are confirmed by pressing key
S3
again or knob
M
of the coder.
The device may realize cycles from 1 to
120 minutes or without the time limitation.
Position
no limit
may be found by rorarting knob
M
counterclockwise.
Time is counted from pressing key
T2
„Start/Stop“
(
fig. 8, page 62
) and finishing of the
automatic pre-heating.
The counting is temporarily interrupted after opening the door or occurrence of less
important alarm. In case of important alarms the cooking process is completely stopped,
and even after removing the problem causing the alarm the process cannot be continued
from the condition before the interruption. It is then required to set the cooking process
again.
After the preset time the device is turned off automatically and switches to Standby mode,
and the acoustic signal is emitted.
6.4.5 Setting of fan speed
Fig. 18
In
AIR CIRCULATION
or
COMBI
use the
display (
S5
, fig. 18
)
to select the fan
speed setting and set the desired speed
by rotating knob
M
clockwise to increase
speed or counterclockwise to decrease it.
Pressing the knob
M
or key
S5
on the
display confirms the selected value.
The device has
6 levels of fan(s) speed
available for the user to select.
Manual
Phase 1/4
Manual
Phase 1/4
Wed 16-04-14 16:15
Wed 16-04-14 16:15