BARTINGTON INSTRUMENTS
Page 9 of 20 OM2448/4
5.3. Top Panel Displays
12. X Signal Value Display
13. Y Signal Value Display
14. Z Signal Value Display
Note:
The displays output the RMS value of the analogue output voltages if in AC mode. If
the device is in DC mode, output is given in DC voltage.
15. Scaling Selection Switch
Caution:
This switch must be set to the scaling corresponding to your magnetometer
output type to ensure correct results (see
Magnetometer Output Type Selection
).
Note:
Where applicable, scaling parameters are indicated by 1V on Magmeter-2, e.g. the
first switch position on Magmeter-2 is 100
µ
T/1V.
16. Backlight
Note:
The button must be pressed and held to enable screen illumination.
15
12
13
14
16
