BARTINGTON INSTRUMENTS
Page 15 of 20 OM2448/4
6.5. Initial Settings
6.5.1. Magnetometer Output Type Selection
Before switching on the equipment, set the magnetometer output type selector switch to the
correct position for your magnetometer. Refer to the appropriate magnetometer datasheets.
7. Using Magmeter-2
7.1. Environmental Precautions
Refer to product brochure DS2520 or maximum environmental, electrical and mechanical ratings
for the Magmeter.
Caution:
Exceeding the maximum environmental ratings may cause irreparable damage to
the equipment.
7.2. Switching On and Off
Caution:
Connect the magnetometer before switching on the Magmeter, as connecting a
“live” cable to the magnetometer may cause damage. Similarly, switch off the Magmeter-2
before disconnecting the magnetometer. See
Connecting the Equipment
.
With the Power switch (item 10 above) ON (position “1”), the power LED (item 9) will be
continuously lit (ON).
Note:
For best results, after switching on the power, leave the Magmeter-2 for 20 minutes
for the internal temperature to stabilise, before performing any measurements.
