BARTEC BENKE HYGROPHIL H 4230-12 Ex Zone II, Operating Instructions Manual, Page: 37 / 112

Installation
31
Operating Instructions HYGROPHIL® H 4230-12 BA 060207
Using the wall mount
Instead of the fixation bars you can just as well fix the device by using the
wall holder type 4220-36 (see section 1.5.2 Accessories).
 Attach the wall mount firmly to the wall. Please pay attention to the
weight of the equipment (up to 23 kg depending on the water reserve).

Insert the cross-strut into the wall mount.

Unscrew the two mounting struts from the rear panel of the equipment.
 Screw suitable clips for hanging the equipment into the two upper drill
holes.

Use the clips to hang the equipment onto the cross-strut of the wall
mount.
 You can correct the horizon-
tal alignment using the ad-
justing screw on the cross-
strut.
3.2 Mobile use
If the equipment is not to be installed for stationary use, you can fix it to the
stand holder type 4220-35 (see section 1.5.2 Accessories).

Place the unit on its front side.
 Unscrew the two mounting struts from the rear panel of the equipment.

Screw the stand/wall mount firmly to the rear panel of the enclosure us-
ing the four M 5 x 12 hexagonal socket-head screws that are supplied
together with the stand/wall mount. Do not use the countersunk head
screws of the mounting struts for this.

Select a solid, vibration-free, horizontal and flat location for setting up
the equipment.

Align the equipment using a spirit level.
 Make sure that the equipment cannot fall over!
The equipment must be fixed securely even for mobile use. The equipment
must never be operated without being fixed. It would otherwise be in danger
of falling over!
You can use the stand holder type 4220-35 to fix device to the wall in the
same way as the wall holder type 4220-36.
Adjusting screw