Barry-Wehmiller Streamfeeder V-710IJ, Manual

Page: 8 / 58

2 V
alue
S
erieS
V-710iJ M
anual
Feature Description
Gate assembly and adjustment
Mounted on a gate bracket assembly above the feed belts, this device
provides a curvature to help preshingle stacked material. When properly
adjusted, a clearance is created to help singulate and feed material.
Table top Used to support the back wedge.
Raised feed belts adjustment Located on each side of the feeder, these adjustment knobs allow you to
raise the rear feed belts above the table top to achieve optimum contact
with material.
Side guide adjustments Dual-knob design allows you to move side guides together or apart for
different size material. Can be positioned equally or offset. (Note: Single-
knob design also available.)
Discharge safety shield
Provides residual risk protection to operator when feeder is running.
Back wedge and adjustments Lifts the material to keep it off the table top, reduces excessive contact
with the feed belts, and helps push the material against the curvature
of the gate assembly. To achieve proper lift, adjustment wing-nuts and
locking levers allow you to slide the wedge to various positions and
angles.
Feed belts Provides the friction and motion necessary to pull individual material from
the bottom of the stack and through the gate assembly area.
Discharge belts Combined with the top roller hold-down assembly, provides the friction and
motion necessary to transport material away from the gate assembly area.
Hold-down assembly
A series of small rollers mounted on movable brackets help to gently hold
material down on the discharge belts as material exits the gate assembly
area. These brackets and rollers are part of the gate assembly and are
removed when the gate assembly is removed.
Control panel components For descriptions, see Figure 1-2A and 1-2B, and Table 1-2.
AC power cord, 8 ft. (2.44 m) IEC320 removal three-prong. Shipped loose.
External run input (optional) This two-wire cable allows the feeder to be turned On or Off with the host
base.
Product Description Section 1
Table 1-1. Main Assemblies Feature Descriptions