Barry-Wehmiller Streamfeeder V-710IJ, Manual

Page: 29 / 58

23
V
alue
S
erieS
V-710iJ M
anual
5
Troubleshooting
Table 5-1 is intended to provide you with quick solutions to the more common day-to-day problems you may
encounter.
Table 5-1. Quick-Look Troubleshooting
Problem
No AC power to
feeder
1. On/Off switch in "Off" (or "O" position).
2. Power cord loose or not plugged into
outlet (or AC power source).
3. Female end of power cable loose or not
plugged into AC power inlet at rear of
feeder.
4. Faulty external run input connection or
cable.
1. Gate assembly improperly adjusted (pos-
sibly more than one sheet thickness).
2. Back wedge improperly adjusted.
3. Worn O-rings (or angled edge).
4. Material interlocking.
5. Static buildup.
1. Material stack height is too low when
stack height is down, resulting in reduc-
tion of down pressure.
2. Binding in side guides.
3. Slippery feed belts.
4. Sheet adhesion or interlocking between
the bottom and next sheet.
Move switch to "On" (or " — " position).
Check and secure power cord at AC
outlet.
Check and secure cord at AC power
inlet at rear of machine.
Check and secure cable connections.
Replace if necessary.
Review gate adjustment procedure.
Review back wedge adjustment proce-
dure.
Rotate O-rings. If applicable, replace
angled edge. If wear is excessive, con-
sult with a qualified technician.
Check material and source.
Check material and source.
Review material loading procedure.
Adjust side guides further apart to allow
freedom of movement between sheets.
Consult with a qualified technician.
Review material loading procedure and
back wedge adjustment procedure.
Feeding doubles
Feed belts are op-
erating, but mate-
rial not feeding
Cause
Solution