Barry-Wehmiller Streamfeeder V-710IJ, Manual

Page: 10 / 58

4 V
alue
S
erieS
V-710iJ M
anual
Feature Description
External run input connector
This 4-pin connector (labeled
External Run Input
) is used to carry start/
stop signals from a vacuum or non-vacuum base to the feeder.
Power On/Off Toggles AC power On or Off.
Fuse holder Contains two replaceable 5-Amp, 5x20 mm time delay fuses.
IMPORTANT: Always make sure power module is replaced exactly as
removed so that “115” is always visible on 115V models and "230" is
always visible on 230V models. Failure to follow this caution can result in
damaged electrical parts.
AC power cordset connector Cordset plugs into this IEC320 connector to provide feeder with power
from a grounded and fused outlet.
Mode switch (optional)
Note: Included with optional external run input only. This slide switch
(labeled Continuous/External Run ) allows you to use the feeder “stand-
alone” or with the optional external run input interface .
Variable speed control This dial switch (labeled Speed ) allows the feeder speed to be
synchronized with a vacuum or non-vacuum base. Turning counter-
clockwise decreases speed; clockwise increases speed. Note: Feeder
motor stops if turned completely counter-clockwise.
Run delay Used to delay (or synchronize) feeder startup with base startup. Range is
adjustable from 0 to 12 seconds.
Table 1-2. Control Panel Feature Descriptions
(optional)