BARRETT 900 SERIES PROGRAMING SOFTWARE
4.0
Connection of the transceiver to the programming PC
5.0
Sending programming information to the transceiver
Connect the transceiver programming cable Barrett P/N BCA90023 from the computers
selected serial port to the Barrett 900 transceiver auxiliary connector.
Connect the transceiver programming cable Barrett P/N BCA94014 from the computers
selected serial port to the Barrett 940 transceiver auxiliary connector..
In the transceiver programming software Main screen select the Transceiver Menu, you will
select Send at the point indicated in the procedure below - this will send the transceiver
configuration for the currently selected client to the Barrett 900 transceiver. The Barrett 900
transceiver will have to be setup to receive the configuration as below:-
On the transceiver to receive information select the Cloning - Programming menu as
described in that transceiver’s operating manual, then using the “Menu” key select as
follows:-
At this point in the transceiver programming software main screen select the Transceiver
Menu, then select “Send”. As the data is transferred the following will be indicated:-
4.1
Barrett 930, 950 and 980
4.2
Barrett 940
PAGE 25
Summary of Contents for 900 Series
Page 30: ......
