![Barrett 900 Series Programming Software Manual Download Page 26](http://html1.mh-extra.com/html/barrett/900-series/900-series_programming-software-manual_3929116026.webp)
If the transfer of programming information is unsuccessful the transceiver will
display the following:-
If this is the case the cable connection should be checked and the programming
procedure repeated.
This procedure is used when transceiver configuration information is to be loaded back into
the transceiver programming software from the transceiver. Before this can be done you
must first create a new client, or you can overwrite an existing client.
In the transceiver programming software Main screen select the Transceiver Menu, you will
select Receive at the point indicated in the procedure below - this will enable the transceiver
programming software to receive the transceiver configuration from the Barrett 900
transceiver. The Barrett 900 transceiver will have to be setup to send the configuration as
described below:-
On the transceiver to send information select the Cloning-Programming menu as described
in that transceiver operating manual, then using the “Menu” key select as follows:-
6.0
Sending programming information from the transceiver
BARRETT 900 SERIES PROGRAMING SOFTWARE
PAGE 26
Summary of Contents for 900 Series
Page 30: ......