Baroness LM2400, Owner'S Operating Manual

Page: 70 / 75

Depressing the brake pedal firmly, move the
parking brake lock lever forward with a foot.
Make adjustments with the adjustment bolt
inside of the tire so that the latch of the
parking brake lock lever is positioned at
arrow A (fourth notch from the bottom). (See
"Adjustment of Brake" (Page 5-12) .)
1
3
2
A
ulabms-006
Adjustment of Parking Brake_001
1 Brake pedal
2 Latch
3 Notch
Adjustment of Brake
Danger Danger
If the brake wire is cut, the machine will be
unable to stop. This would be extremely
dangerous.
If the brake wire is cracked or damaged,
replace it with a new one immediately.
If the brake is not sufficiently effective, adjust
the brake wire.
Adjust the brake by tightening the brake wire
adjustment bolt.
3
4
2
1
nfzln9-002
Adjustment of Brake_001
2.
1 Lock nut
2 Adjustment bolt
3 Brake wire
4 Brake lever
Break-in of Brakes
If the brake shoes or brake pads are worn,
replace them with new ones.
Immediately after replacement, drive to break
in the brakes if the effectiveness of the brakes
is low.
While driving, lightly operate the brakes to
break in the contact areas.
Adjusting the Neutral Position of the
Piston Pump
Caution
Make sure not to touch rotating tires.
Caution
When adjusting the neutral position, pay
close attention to abrupt start of the machine.
Place the jacks beneath the jack-up points,
and then lift the machine until all the tires get
off the ground.
If the machine moves forward or backward while
the traveling pedals are released, they are not
set to the neutral position.
Follow the steps below to make adjustments.
Stop the engine.
Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
(See "Jack-up Points" (Page 5-4) .)
Make sure that no tires get contact with the
jack stand.
Start the engine, and rev it up to the
maximum rpm.
Adjust the neutral position.
Loosen the lock nuts.
1.
2.
3.
4.
5.
[1]
LM2400
Maintenance
Page 5-12 Maintenance (Main Body)