Baroness LM2400, Owner'S Operating Manual

Page: 67 / 75

Insert two or three strips of newspaper into
the space between the reel cutter (cutting
cylinder) and the bed knife (bottom blade) at
an angle of 90 degrees. Then, rotate the reel
cutter (cutting cylinder) counter-clockwise
(when you face the mower unit from the left)
to check the sharpness of the blades.
Check the sharpness at entire range (three
or four points from left edge to right one) of
the reel cutter (cutting cylinder).
Using a piece of chalk, mark locations on the
blade that are sharp.
Shift only the reel rotation/stop switching
levers of the hydraulic motors in the mower
units to be used for back lapping to the
"Rotate" position.
Shift the levers to the "Stop" position for the
mower units for which you will not perform
back lapping.
1
A
B
2f8equ-002
Back Lapping of Reel Cutter (Cutting Cylinder)_002
1 Reel rotation/stop switching lever
A Rotate
B Stop
Lower all mower units to the ground, and
then stop the engine.
Move the mower unit up/down lever to the
neutral position.
1
B
C
A
zhz6po-004
Back Lapping of Reel Cutter (Cutting Cylinder)_003
2.
3.
4.
5.
6.
7.
1 Mower unit up/down lever
A Neutral
B Up
C Down
Open the hood, and then set the reel reverse
switch to the "ON" position.
1
A
B
kp6cmu-001
Back Lapping of Reel Cutter (Cutting Cylinder)_004
1 Reel reverse switch
A ON (Rotate)
B OFF (Stop)
Sit on the seat, apply the parking brake, and
then start the engine.
Run the engine at a low rpm.
Shift the mower unit up/down lever to the
"DOWN" position, and the reel cutter (cutting
cylinder) will rotate for back lapping.
1
B
C
A
zhz6po-004
Back Lapping of Reel Cutter (Cutting Cylinder)_005
1 Mower unit up/down lever
A Neutral
B Up
C Down
With the reel rotation/stop switching lever,
adjust the rotation speed of the reel cutter
(cutting cylinder).
8.
9.
10.
11.
12.
Ma
intena
nce
LM2400
Maintenance
Page 5-9 Maintenance (Mower)