Barkey 212.10043, Instructions For Use Manual

Page: 27 / 72

Operation
The text "OK" at bottom centre now indi-
cates that the confirm button is assigned
the acknowledge function. Pressing the
confirm button ("OK") automatically re-
starts the Barkey plasmatherm and dis-
plays the main screen with the user menu.
Figure 7: Confirmation with "OK" is possible
4.1.5 Filling
To fill the device you will need approx. 9 litres of distilled or demineralised water and
two micropur tablets.
►
When filling the device from empty, switch the device on with the On/Off button.
It will now display a message asking you to fill the water.
►
To fill with water, select the fill level display described in the Chapter Filling with
water from the menu.
►
Place two micropur tablets in the filler opening.
CAUTION
Always add two micropur tablets to the distilled or de-mineralised water.
For devices supplied new or exchange devices, or following maintenance and re-
pairs, the two micropur tablets are always already inside the tank for the heat trans-
fer fluid.
►
Place a suitable funnel in the filler opening and fill up the device with the necessary
quantity of de-mineralised or distilled water:
approx. 9 litres when filling from empty
approx. 1 litre when topping up after a warning or error message prompting you
to top up
►
Stop filling immediately you hear the acoustic signal and see the message "Tank is
FULL".
►
Acknowledge the message with the confirm button ("OK").
►
Screw the plug back into the filler opening. Use a coin or similar to tighten the plug.
The device is now correctly filled with heat transfer fluid.
F i l l l ev e l
T a n k i s F U L L
O K