Annuncicom
User Manual Version 4.07
Relay While Audio
Activate relay when sound is coming out of the analog output and deactivate when not.
Default setting is
"OFF".
Stream
There are two ways streaming can be set up:
1) Automatically by responding to the last calling station
(to the device from where the last communication came, viz. "to the origin source").
2) By means of Tables containing IP addressing information.
Refer to section 3.5 Table Settings for information on configuring tables.
Choose if the stream should be sent to the defined entries in the table or "to the origin source".
Current Table
There are 8 tables available, each with 8 entries. Only one table is in use at any particular time.
This parameter shows the current table selected over the remote command interface or the home page.
Multicast Address
Enter a Multicast address on which to receive an audio stream. As receive port the "UDP Receiver Port" is
taken. At start up the device will join the multicast group by periodically issuing IGMP join group messages.
Default setting is no address set,
"0.0.0.0".
3.4.4 I/O Settings
These settings adjust the device behaviour for startup, inputs and outputs (attached buttons, the serial CTS
signal and the relay pulse duration).
Command Broadcasting
This option is for backward compatibility with firmware versions prior to 1.16. If you want "r=c=" commands
to be broadcast (UDP broadcast), set to
compatibility mode. Otherwise choose secure mode, then "r=c="
commands will be sent only if
stream to origin source is set and the origin source is known (command will be
sent to the last partner).
BARIX AG
| 28. Jan. 2014 | Configuration | Page 20/54
Summary of Contents for Annuncicom
Page 2: ......
