Free Cooling Unit System
This Bard Free Cooling Unit system is composed of FUSION-TEC wall-mounted air conditioners matched with an
LV1000 first on/next on controller. The wall mounts are specifically engineered for telecom/motor control center
rooms.
NOTE:
The LV1000 controller and FUSION-TEC wall-mount units are designed specifically to work together. The
LV1000 controller cannot run other Bard models or other brands of systems, nor can other controllers run
the FUSION-TEC wall-mount units. They are a complete system, and must be used together.
Controller
LV1000 controller and accessories included shown below.
Remote Temperature/
Humidity Sensor*
(with 35' shielded cable)
Bard P/N 8403-079
Communication
EMI Filters
Bard P/N 8301-055
TEC-EYE
TM
Hand-Held
Diagnostic Tool
Bard P/N 8301-059
LV1000 Series
* One remote temperature/humidity sensor and 35' of shielded cable are included with the LV1000 controller.
Up to two additional remote temperature/humidity sensors can be purchased and installed. Temperature-only
sensors (Bard P/N 8301-058) may be used instead of the additional temperature/humidity sensors, but will
also need to be purchased separately.
LV1000 Series
Programmable Logic
Controller
The equipment covered in this manual is to be installed
by trained, experienced service and installation
technicians.
These instructions should be carefully read before
beginning the installation. Note particularly any tags
and/or labels attached to the equipment.
While these instructions are intended as a general
recommended guide, they do not supersede any national
and/or local codes in any way. Authorities having
jurisdiction should be consulted before the installation is
made. See
Additional Publications
for information
on codes and standards.
Shipping Damage
Upon receipt of equipment, the cartons should be
checked for external signs of shipping damage. If
damage is found, the receiving party must contact
the last carrier immediately, preferably in writing,
requesting inspection by the carrier’s agent.
Additional Publications
These publications can help when installing the
furnace. They can usually be found at the local library
or purchased directly from the publisher. Be sure to
consult the current edition of each standard.
National Electrical Code ......................ANSI/NFPA 70
Standard for the Installation of Air Conditioning
and Ventilating Systems ...................ANSI/NFPA 90A
Standard for Warm Air Heating
and Air Conditioning Systems ............ANSI/NFPA 90B
Page
3 of 36
GENERAL INFORMATION