Barco – TransForm A – DOC-3358-2 – service manual – Revision 06 – March 2007
__________________________________________________________________________
4-6
4.2.1
Inserting cards into a TransForm A device
•
Open the case of the device, please see section
2.1.5 Opening the top cover of the Processor
Opening the top cover of the OmniBus A18
2.4.5 Opening the top cover of the Extender
!
•
The PCI slots (and PCIe slots on AGS-3389 respectively) are arranged next to each other close to the backside
of the mainboard.
Figure 4-2
PCI slots on P
ROCESSORS
AGS-3328 (top left), AGS-3389 (top right), AGS-3390-1/-2 (bottom left) and O
MNI
B
US
A18 (bottom right)
•
Remove the bracket on the slot you intend to use. Keep the screw you have to remove and keep the bracket
for possible further use.
•
Examine the card before removing from the anti static bag. If there is any visible damage, do not install the
card and contact Barco.
•
Do not remove the card from the anti static bag until you are ready to install it. Use a grounded workplace.
Do not lay parts on the anti static bag. Only the insides are antistatic.
•
If you are inserting a Multiport I/O Card please check the jumper settings and order of the card first, see
section
.
•
Carefully align the card’s connectors with the socket and press firmly. The ISA retainer at the end of the card
must be fitted into the respective guide.
In a Processor
AGS-3390-1/-2
the guide may be too far away to fit. Instead the transportation lock
serves for this purpose.
