Barco Solaris LD 120-8, Installation & Service Manual

Page: 12 / 88

2. Installation requirements
2.2 Installation requirements for the Solaris D2 digitizer
Requirements
• The Solaris D2 digitizer should not be placed in a built-in installation or enclosure unless proper ventilation is provided.
• When using the unit in a multi unit rack assembly or closed assembly, the ambient temperature inside the assembly may not
exceed the maximum rated ambient temperature of the digitizer. The installation should be such that the amount of air flow
required for safe operation of the equipment is not compromised.
• When building in the Solaris D2 digitizer into a rack with cover door, be aware that a space of minimum 85 mm is needed
between the indicated reference and the cover door. This space is needed to guide the input cables to the inputs.
85 mm
• The Solaris D2 digitizer will require that air flows freely in vent holes. Blocking these holes will greatly reduce the reliability of
the unit and lead to the possibility of overheating.
• The Solaris D2 Digitizer should operate from an AC power source. The Solaris D2 digitizer is equipped with an auto-ranging
power supply from 85 to 264 volt (50–60 Hertz).
• When installed in a rack, the mounting should be such that no hazardous condition is achieved due to uneven mechanical
loading.
• When the mains switch located on the back of the Solaris D2 digitizer is not accessible due to rack mounting, the socket outlet
supplying the rack shall be installed near the equipment and be easily accessible or a readily accessible disconnect device shall
be incorporated in the fixed wiring. When using a rack in an installation it is advisable to log the serial number of the device and
to activate the warranty figure by registering utilizing the included form.
• Do not place the Solaris D2 digitizer on an unstable cart, stand or table. The device may fall, causing personal injury and
serious damage to the digitizer.
• The data path between the Solaris D2 digitizer and the Solaris LD display may not exceed five (5) meter.
2.3 System requirements for the Control software
System requirements
• A minimum configuration of a Pentium II processor, 160 MHz and 128 MB of RAM.
• At least 50 MB of disk space.
• A CD-ROM drive.
• The operating system required is a 32 bit Windows version:
- Windows NT 4.0. with service pack 4.0
- Windows 2000
- Windows XP
• Microsoft Internet Explorer 5.5 or higher.
• The screen resolution of the software is 1024*768 for a good working environment.
8 R5976773 SOLARIS LD DISPLAY 02/12/2004