Barco SIM 5H, Owner'S Manual

Page: 34 / 173

4. Installation
3 Address key
(Recessed key), to enter the address of the projector (between 0 and 9). Press the recessed
address key with a pencil, followed by pressing one digit button between 0 and 9
4 LOGO Switch between displaying the internal or external pattern in the Geometry Distortion and the
Shape (Blanking) dialogbox.
5 PAUSE To stop projection for a short time, press ’PAUSE’. The image disappears but full power is
retained for immediate restarting.
6 STANDBY Standby button, to start projector when the power switch is switched on and to switch off the
projector without switching off the power switch
Attention: Switching to Standby. When the projector is running and you want to go to
standby, press the standby key for 2 seconds.
7 MUTE Not used
8 Auto image Allows to adjust the image automatically ( center the image on the active chip surface).
9 Digit buttons Direct input selection
10 Lens control Use these button to obtain the desired ZOOM, SHIFT, FOCUS
11 VOL Not used
12 Picture Controls Use these buttons to obtain the desired picture analog level
13 DIGI ZOOM Not used
14 FREEZ Not used
15 PIP Not used
16 ENTER To con fi rm an adjustment or selection in the menu
17 Cursor keys To make menu selections, to perform bare scale adjustments or to zoom/focus when the direct
access is active
18 BACK To leave the selected menu or item (go upwards to previous menu)
19 RCU operation
indication led Lights up when a button on the remote control is pressed. (This is a visual indicator to check
the operation of the remote control)
30 R59770247 SIM 5H 04/06/2008