Service Mode
10-2
5975618A RETRO BLOCK GRAPHICS 2100LC 240898
SERVICE
BARCO LOGO
PRESET INPUT BALANCE
60Hz TRACKING
I2C DIAGNOSIS
MORE...
Select with
ê
or
é
then <ENTER>
<EXIT> to return.
I2C DIAGNOSIS
D CA
INPUT/AUDIO
PCF8574 48H # # #
DECODER
PCF8574 4EH # # #
LAMP DRIVER
PCF8574A 72H # # #
INPUT/AUDIO
PCF8574A 74H # # #
AUDIO
TEA6310T 80H # # #
DECODER
SAA7151B 8AH # # #
DECODER
SAA7152 B2H # # #
DECODER
SAA7192A E0H # # #
WARNING
PRESET INPUT BALANCE
is reserved to
qualified
service personnel
<ENTER> to accept
<EXIT> to return
Identification
To display the Identification screen, push the control disc up or down
to highlight
Identification
and press
ENTER
.
The Identification screen gives following overview :
- Type of projector
- Projector address
- Software version
- Installation configuration
- Baud rate
- Text ON
- Projector serial number
- Projector run time
BARCO LOGO
STATUS [OFF]
BACKGROUND [OFF]
SHIFT
HOT KEY [OFF]
Select with
ê
or
é
<ENTER> to toggle/select
<EXIT> to return
-
Software version
-
Proj. Address
: to change the address of the projector, see Change
Projector Address in this chapter.
-
Installation
: possible installations :
* Front/Ceiling
* Front/Table
* Rear/Ceiling
* Rear/Table
To change the installation configuration, follow the instructions in
chapter Installation Set Up.
-
Baud rate
: transfer speed for communication with a IBM PC (or
compatible) or MAC. The baud rate of the projector must be the same
as the baud rate of the connected computer. When there is a
difference, consult 'Change Baudrate PC' in this chapter.
-
Projector Run Time
: gives the total run time since the first start up.
All projectors leave the factory with a run time of approximately 24
hours.
-
Projector Serial number
: indicates the fabrication number of the
projector. This number can be useful when calling for technical
assistance
60 Hz TRACKING
is reserved to
qualified
service personnel
<ENTER> to continue
<EXIT> to return
-
Type
of projector : RETRO BLOCK GRAPHICS 2100LC
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
LAMP DRIVE MODE
MORE...
Select with
ê
or
é
then <ENTER>
<EXIT> to return.
SERVICE
IDENTIFICATION
CHANGE PASSWORD
CHANGE LANGUAGE
CHANGE PROJ. ADDRESS
CHANGE BAUDRATE PC
RESET LAMP RUNTIME
LAMP RUNTIME HISTORY
LAMP DRIVE MODE
MORE...
Select with
ê
or
é
then <ENTER>
<EXIT> to return.