Barco R9006332B1, User Manual

Page: 55 / 92

RLM W14 17/04/2017
47
8.Image
H Start
Use to adjust the projected image’s horizontal position.
If the projected image is not at the center of the screen (i.e. shifted to right or left) and ends up being cropped, use this
function to adjust the image’s horizontal position.The following image is an example of test image from an external signal
source:
Native picture Skewed left Skewed right
H Phase
Use  to adjust the projected image’s phase.
Use this function to adjust the phase of pixel sampling clock (relative to input signal). Should the image still flicker or show
noise (i.e. edges on texts) after optimization, adjust phase accordingly.
Phase only available with analog data sources
V Start
Use  to adjust the projected image’s vertical position.
If the projected image is not at the center of the screen (i.e. shifted up or down) and ends up being cropped, use this function
to adjust the image’s vertical position.The following image is an example of test image from an external signal source:
原始圖面 圖面下偏 圖面上偏
Native picture Skewed down
Skewed Up
It is recommended that when adjusting the image, the horizontal total should be adjusted before the
horizontal phase. However, if the image still flickers even after you have adjusted both, try lowering the
image noise.