Barco ILite, Installation Manual

Page: 62 / 110

7. Basic setup procedures
C
B
A
Image 7-33
5. Place the truss beam upon the joined rental tiles. The positioning pins at the top of the rental tiles must fit into the positioning
holes at the bottom of the truss beam.
Caution: Ensure that the front of the truss beam has the same orientation as the front of the rental tiles.
Caution: Be careful not to damage the rental tiles
Image 7-34
6. Close the safety clamps of all rental tiles as illustrated.
Image 7-35
7. Release the latches of all rental tiles, by sliding the tilt clip away from the latch. Ensure that each latch is completely hooked over
the latch receiver of the truss beam.
58 R5976189 ILITE RENTAL DISPLAY 16/09/2005