Barco HDX 4K, User Manual

Page: 53 / 107

6. Getting Started
- When ’0’ is pressed, the projector is switched off.
- When ’I’ is pressed, the projector is switched on.
The projector starts up to standby mode. The Power on/off button will blink until standby mode is achieved. Once in standby
mode, the Power on/off button will be lit WHITE, but the display will be off.
2. Press the Power on/off button on the projector, or the Power On button on the remote control.
The projector will continue to power on mode. The Power on/off button will blink until the projector is ready. Once the projector
is ready, the Power button will be lit BLUE.
The start up screen is displayed on the touch panel and when fully started up, it changes to the overview screen.
1
2
Image 6-2
The current mains input voltage is indicated on the voltmeter just above the power switch.
The background image of the startup screen and info screens can be changed with Projector Toolset with an
installed HDX plug-in.
Status overview
Once the projector is started, press Status to get an overview of parameters such as :
• Chosen source
• Refresh rate
• Current resolution
• Device serial number and article number
• Current Firmware version
• Lamp runtime in hours
• Current illumination (in percent)
• Chosen communication method and IP address (if connected)
• Warp status
• Environmental temperature
Starting image projection
1. Make sure the available sources are connected to the appropriate input ports.
2. Press the Input Selection button on the keypad or on the remote control until:
- the LED of the selected source lit up GREEN, and
- the image of the selected source is projected.
1 2
Image 6-3
R5906070 HDX 4K 23/09/2016 49