Barco Galaxy NW-7, User Manual

Page: 45 / 220

5. Setup
5. SETUP
Overview
• Powering up the projector
• Starting up the projector
• Setting up the Remote Control Unit address
• Setting up the projector address (only if necessary)
• Setting up the orientation
• Adjusting the lens
• Setup the baud rate for serial communication
• Preferences
• Setup of the Linked projectors in a Multichannel system
5.1 Powering up the projector
How to power up the projector ?
1. Switch the power switch to “1”
'(6.723,1387 '(6.723,1387
535 535 *< *< %3% %3% +V&V +V&V 9V 9V 9,'(2 9,'(2 69,'(2 69,'(2
,1 ,1 ,1 ,1
/ /
67(5(2,1387 67(5(2,1387 67(5(2287387 67(5(2287387
/ / / /
,1 ,1 ,1 ,1 ,1 ,1 ,1 ,1
56& 56& '9, '9, 5& 5&
0
1
'9, '9, '9, '9,
Image 5-1
Power switch
2. The software will be initialized. This may take up to 30 seconds. During this phase the LCD display is lit (1). The initialization is
followed by the keypad lighting up brie fl y (5 seconds) and the projector Standby status (2) .
Galaxy NW-12 standby
1
2
Image 5-2
Switch ON sequence
R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013 41