Barco Galaxy NW-7, User Manual

Page: 190 / 220

7. Advanced
7.11.4 Operation options
Overview
• AutoImage
• Warning messages
7.11.4.1 AutoImage
What can be done ?
AutoImage can be disabled. In case of a new (unknow) source, no automatic fi le selection will be done. Instead, a more or less
suited fi le will be selected, resulting in a misaligned image. Image settings must be done manually (edit image fi le).
How to enable/disable AutoImage ?
1. Press MENU to activate the Tool bar
2. Press → to select the Service item
3. Press ↓ to Pull down the menu
4. Use ↑ or ↓ to select Operation options
5. Press → to pull down the menu
6. Press ↓ to select Autoimage
7. Press → to pull down the menu
8. Use ↑ or ↓ to select On/Off
9. Press ENTER
Image 7-244
A white bullet shows the active setting
7.11.4.2 Warning messages
What can be done?
It is possible to block some Warning messages during projector runtime. The table below gives an overview of those messages that
can be suppressed during runtime.
Warning message Sim 5W Galaxy NH-12
Galaxy NW-12
Galaxy NW-7
Description
NO SIGNAL
x x
In case no incoming Sync is detected
Lamp error icon
x
In case of an actual lamp or LPS problem
Lamp runtime warning
x x
Max lamp runtime almost reached
Lamp runtime exceeded
x x
Max lamp runtime exceeded
Desktop resolution not valid
x
Desktop input signal resolution is out of
speci
fi cation.
Wait box
x x
An hourglass icon that is displayed during
processing
For safety reasons, the warning messages Lamp runtime warning and Lamp runtime exceeded will always
pop up during start-up of the projector. They can only be suppressed during projector runtime.
186 R59770288 GALAXY NW-12, GALAXY NW-7 20/06/2013