3. Engine replacement
DMD
1
A
1
A
1
B
2
B
2
A
3
B
3
A
3
A
2
A
3
A
+
3
B
2
B +
3
A
2
B +
3
A
3
B
2
A +
1
B
Image 3-89
Convergence controls of the red formatter
Caution:
Remember to release the adjacent control, prior to tightening the desired control. E.g. to shift the red image left
down, release 1B (turn a bit counterclockwise) before tightening 1A (clockwise).
5. Lock the position of the red formatter by carefully tightening the securing screws in the following sequence (hand-tight):
-
tighten screw 1, while holding screw 3 in position
-
tighten screw 3, while holding screw 1 in position
-
tighten screw 4, while holding screw 2 in position
-
tighten screw 2, while holding screw 4 in position
DMD
2
1
3
4
Image 3-90
Securing screws of the formatter support plate
Note:
Tightening the securing screws can cause small changes to the alignment.
6. Re-check the convergence of red on blue and repeat the steps above if needed
7. Switch to the convergence pattern: green on blue
44
R59770591 ENGINE KIT 26/08/2010