3. Engine replacement
6. Adjust screw 2 (see image 3-66) until the highest light output is measured
7. Adjust screw 3 (see image 3-66) until the highest light output is measured
9. Use an open ended nut spanner to keep the adjusting nuts in position, while tightening the counter nuts (hand-tight)
3.4.4
Scheimp
fl
ug adjustment
C
AUTION
:
The Scheimp
fl
ug adjustment is a very delicate operation and may only be done by trained and
Barco quali
fi
ed technicians.
Overview
•
•
3.4.4.1
Description of the Scheimp
fl
ug adjustment
Scheimp
fl
ug principle
When the
panel plane
(plane where the image is created, such as DMD or LCoS panel) and
lens plane
(plane of the
principal lens of the projection lens) are parallel, the
focus plane
(plane where the full image is well focused) will be
parallel to these two planes. If, however, the lens plane is tilted with respect to the panel plane, the focus plane will
also be tilted according to geometrical and optical properties. The intersection of the panel plane, the lens plane and
the focus plane will be a line in this situation.
Introduction
If the DMD plane (
A
), the projection lens plane (
B
) and the screen plane (
C
) are parallel, the image projected on the screen will be
in focus (sharp image).
1
2
3
A
B
C
Image 3-67
Scheimp
fl
ug: parallel planes
If the lens is slightly tilted, resulting in a tilted lens plane
B’
, the focus plane
C
will tilt in such a way that the intersection of the panel
plane
A
, the tilted lens plane
B’
and the tilted focus plane
C’
is a single line.
R59770591 ENGINE KIT 26/08/2010
33
